| sponsored by
Zeiner's Bass Shop
The Kansas Angler Online
and Swim Tail Lures
STRIPED BASS HYBRIDS:
Innovative KDWP fish culture
project producing home-grown hybrids
PRATT - One
might call it Frankenfish. The striped bass/white bass hybrid
- more commonly called the "wiper" - is the undisputed
terror of Kansas fishing waters. No fish, pound-for-pound, fights
as hard as a wiper, and this tenacity has made it an increasingly
popular quarry for the state's anglers.
Producing enough wipers to fill
the demands of Kansas anglers is no easy task, however. Striped
bass (or stripers) have been stocked in several Kansas reservoirs,
but extreme summer water temperatures can limit their survival.
Even in waters where stripers survive, their populations can't
reliably provide wild females needed for a wiper production program.
For this reason, Kansas historically
relied on fish trades with other states for wipers. However,
this left the program at the mercy of annual fluctuations of
available fish in other states. In addition, trading for fish
from other states ran the risk of accidental introduction of
unwanted species, as happened when white perch were sent to Kansas
and inadvertently stocked in Wilson and Cheney reservoirs.
There had to be an answer, and
the Kansas Department of Wildlife and Parks (KDWP) Milford Fish
Hatchery would provide it. In 1993, the hatchery launched an
experimental program to maintain a domestic striped bass broodstock
population in the hatchery. If successful, the need for trades
could be eliminated and control of the hatching process increased.
The first step was to stock
hatchery ponds with striped bass fry, 100,000 to 200,000 per
pond. These ponds contained no other fish and were high in zooplankton,
a necessary food source for the growing fry. After 30 days, the
fish were 1 to 3 inches long and ready to be transferred to culture
tanks inside the hatchery. Here, they were trained to eat a pelleted
food and grown to an average length of 4 inches before being
transferred to raceways outside the hatchery. This would be their
Four feet deep, 8 feet wide,
and 100 feet long, the concrete raceways contained flowing water
at a constant temperature of 58 degrees, ideal for stripers.
Here, they thrived on their artificial cuisine and cool temperatures
until they were old enough to breed - at age four.
Thus, the first domestic striped
bass spawning in a Kansas hatchery occurred in 1997 and has continued
annually. But rearing the fish proved much easier than spawning
and producing wipers. To enhance egg development, the fish had
to be switched from pellets to a live fish diet 30 to 45 days
before spawning. Usually in early May, 12 females were selected
for propagation and transferred to tanks inside the hatchery.
Here, the were gradually acclimated to water temperatures of
66-68 degrees, ideal for spawning. All environmental factors
- from lighting to disturbance and handling - could be controlled
here, reducing stress on the fish.
After three days in their new
environment, the fish were injected with human chorionic gonadotropin
(HCG), a human hormone that facilitates successful reproduction.
HCG speeds ovulation and induces a more predictable spawn. Eggs
became fully-developed in just 18-30 hours after injection, requiring
At this point, the culture process
becomes even trickier. Eggs remain fertile only 30 minutes after
ovulation, so the fertilization process must be timely and precise.
Milt (fluid containing sperm) from wild white bass is stripped
from the males precisely into pans with the eggs. The eggs accept
milt for only two minutes, and once the milt is activated by
water, it remains viable for only 30 to 60 seconds.
A female striped bass may produce
more than one million eggs, depending on the size of the fish.
Fertilized eggs are placed in special hatching jars where they
can be continually monitored and dead eggs removed. Once the
eggs hatch, the fry swim to the top of the jar and through a
common trough emptying into a fry holding tank. These new wiper
fry stay here for 9 days. From there, they may be stocked directly
into state waters or placed in hatchery ponds and raised to fingerling
size or larger for later stocking.
The early efforts were a learning
process, with low hatch rates. By 2004, however, the success
rate was up to 30 percent, providing a treat for anglers across
the state through a process that is rare in the United States.
Milford Hatchery is one of a handful of places that maintains
a domestic broodstock solely for spawning.
For more information on this
subject, pick up a copy of the March/April issue of Kansas
Wildlife & Parks magazine. Look for the article entitled
"Wipers For the Future," by Derek Schneidewind. For
detailed information on wiper stocking in Kansas, visit the KDWP
Fishing News Archives
Back to Fishing News from
Bass Shop | Kansas
Angler Online |